Yes, you need an alignment after replacing strut mounts. The purpose of the alignment is to correctly adjust the suspension components so that your vehicle handles properly and rides smoothly on any road surface. During a wheel alignment, technicians measure the angles of the wheels relative to each other and also check for proper tire inflation, wear patterns, and tread depth. … [Read more...] about Do You Need an Alignment After Replacing Strut Mounts
Car Problem Solution
Can a Bad Battery Cause Electric Power Steering Problems
Yes, a bad battery can cause electric power steering problems. If the battery isn't able to provide enough power to the steering system, it won't be able to operate properly and may begin to malfunction. Additionally, if the alternator is not charging properly due to an old or failing battery then this too can cause issues with the electric power steering. When either of these … [Read more...] about Can a Bad Battery Cause Electric Power Steering Problems
How to Reset Hvac Blower Sleeper Fuse
To reset a HVAC blower sleeper fuse, start by turning off the power to the system. After that, locate the switch on your furnace and make sure it is switched off. Next, open up the access panel of your unit and find the fuse box. Remove any covers or panels in order to reveal fuses which are usually located near where wires connect to a terminal block or mounting plate inside … [Read more...] about How to Reset Hvac Blower Sleeper Fuse
Can You Use a Used Ecm
Yes, you can use a used ECM (Engine Control Module), however it is not recommended. Used ECMs must be properly tested for compatibility with your vehicle and its specific engine control system before installation. In addition, even if the used ECM is compatible with your vehicle's engine control system, it may still have been damaged from prior use or hinder its performance due … [Read more...] about Can You Use a Used Ecm
Does a Transmission Control Module Need to Be Programmed
Yes, a transmission control module (TCM) needs to be programmed in order for it to function correctly. The TCM is responsible for managing the shifting of gears in an automatic transmission system, and is usually found on vehicles that have electronic shift controls. In order for the TCM to work properly, it must be programmed with specific parameters such as engine RPMs, … [Read more...] about Does a Transmission Control Module Need to Be Programmed