If you spill oil on your engine, it is not necessarily bad. However, if the oil is not cleaned up in a timely manner, it could cause damage to the engine. Oil can cause corrosion and other problems if it is not removed promptly. If you spill oil on your engine, it's not the end of the world. However, it is important to clean it up as soon as possible. … [Read more...] about Is It Bad If I Spill Oil on My Engine
Does Timing Affect Air Fuel Ratio
The timing of the air/fuel mixture affects how much power the engine produces. If the mixture is too lean (not enough fuel), the engine will run hot and may damage itself. If the mixture is too rich (too much fuel), the engine will run cold and will not produce as much power. A lot of people ask me if the timing of their air/fuel mixture has anything to … [Read more...] about Does Timing Affect Air Fuel Ratio
How to Winterize a Popup Camper
To winterize a popup camper, you will need to empty all the water tanks, including the fresh water tank, and flush the lines with clean water. You will also need to remove any food from the camper and put it in a storage container. Next, you will want to disconnect the battery and propane tanks. Finally, you will want to cover the camper with a tarp or other waterproof material … [Read more...] about How to Winterize a Popup Camper
How to Put a Jeep in Neutral Without Key
There are a few ways that you can put a Jeep in neutral without using the key. One way is to disconnect the battery. This will disable the electrical system and allow you to shift the transmission into neutral. Another way is to remove the fuse for the ignition system. This will also disable the electrical system and allow you to shift the transmission into neutral. Finally, … [Read more...] about How to Put a Jeep in Neutral Without Key
How to Test Wire Harness
There are several ways to test a wire harness. The most basic way is to use a continuity tester or multimeter to check for continuity between the two ends of each wire in the harness. This will tell you if there is a break in the wire or if any of the wires are shorted together. Another way to test a wire harness is with an ohmmeter. This will measure the resistance of each … [Read more...] about How to Test Wire Harness

