Car Problem Solution

My ABS light being on after changing the wheel bearing could be due to a variety of different issues. If the new wheel bearing was installed incorrectly, it may cause premature wear and trigger an ABS fault code. It is also possible that the Anti-lock Braking System (ABS) sensor or tone ring for the affected wheel has become damaged during installation and needs to be replaced. … [Read more...] about Why is My Abs Light on After Changing Wheel Bearing

To test a yaw rate sensor, you will need to first find the vehicle’s center of gravity. This can be done using either a jig or by taking measurements from the wheelbase and track width. Once this is established, you can then place your vehicle on a flat surface with all four wheels in contact with the ground. Then start the engine and use an accelerometer to measure any changes … [Read more...] about How to Test Yaw Rate Sensor

Steering wander can be a dangerous and annoying problem that can occur in cars. The first step to fixing steering wander is to check the alignment of your car's wheels. Make sure all four wheels are properly aligned, including toe-in and camber angles. If the alignment is off, it should be corrected as soon as possible. Next, make sure there are no loose parts or worn … [Read more...] about How to Fix Steering Wander

No, you cannot use Lucas Transmission Fix in a CVT transmission. CVTs are continuously variable transmissions that have no gears and work differently than traditional automatic or manual transmissions. Therefore, they require different additives and treatments than those used for standard gearbox type transmissions. Consequently, using Lucas Transmission Fix in a CVT will not … [Read more...] about Can You Use Lucas Transmission Fix in a Cvt Transmission